Your shopping cart is empty!
Product Compare (0)
This plastic line guide is designed to secure the ABS hydraulic lines to the monocoque chassis/frame..
These plastic guides are used on a wide variety of models (typically those with ABS fitted) to attac..
This cable guide bolts to the clutch cover casing and is designed to correctly route the starter mot..
This guide is located at the rear of the engine and is used to route the fuel breather/drain hose, a..
This small rubber grommet that fits underneath the filler cap, allows fuel vapour to escape to atmos..
These are the rubber end caps that fit into the handlebar tubes on many Ducati models. Check specifi..
This bracket allows you to mount the cast block to the sub-frame, to which the number plate holder i..
This rubber bush is used on the Panigale headlight, where it mounts to the front subframe. These oft..
This genuine Ducati rubber pipe comes complete with it's own heat protective sheath (as per OEM fit)..
This O-ring (rubber gasket) is used on the Panigale to seal the water distributor housing to the cyl..
This rubber guide is used on the Panigale to route the ignition (spark plug) lead through the electr..
This rubber grommet, measuring 12mm outside diameter, 6mm internal diameter and 7mm thick, to fit pa..
These rubber inserts are used extensively on a number of models and are prolific on the Panigale. As..
This rubber pad serves a dual purpose. It can be fitted to the rear sub-frame, to protect it at the ..